MONGOOSE M80 3 BTN REMOTE - RED - 433MHz
Description
Part# MRC83R - Red LED - 433Mhz
Current - from mid 2011
Battery type: CR2032 x 1
Not interchangable with each other. The above frequencies are allocated by NZ Radio Service for 'short duration transmission' vehicle security use. Compliance N4096 Z333
Replacement plastic case: Part# 242183
A new remote has to be memorised into your security system for it to operate - this is called 'code learning'. The coding instructions can be found in your owners manual (which you can download from our website if yours is misplaced) or is detailed below.
To learn new remotes to M80 models:
Disarm by existing remote, or use the override
- Open the drivers door and leave open
- Turn the ignition ON/OFF 3 times - siren chirps
- Press arm button on first remote (siren chirps)
- Press arm button on second remote (siren chirps)
- Repeat for any other remotes
Wait 10 seconds for learning process to complete
To learn new remotes to M80II & M80GII models:
1: Disarm – open driver’s door (Keep door open while programming) - LED starts fast flashing
2: Within 10sec turn IGN on - the LED will now light solid for 10 seconds
3: Within 10sec, turn IGN OFF then back ON
4: The LED stays on & the siren chirps 3 times to confirm remote code learning mode
5: Press button one on the new remote - siren chirps once to confirm
6: Press button one on a 2nd remote you wish learnt – siren chirps twice to confirm
7: To finish, turn the ignition off or wait 10 seconds to end of programming - siren chirps quickly 3
times
NOTE: When learning a new replacement or additional remote, the original remote(s) must
be re-learnt or they will be erased from memory and will not operate this system.
